Planet XGS3-24042 User Manual download pdf (Page 68)

100

101

4-14

Figure 4-2 Typical topology for switch upgrade in BootROM mode

The upgrade procedures are listed below:

Step 1:

As shown in the figure, a PC is used as the console for the switch. A console cable is used to connect PC to

the management port on the switch. The PC should have FTP/TFTP server software installed and has the

image file required for the upgrade.

Step 2:

Press “ctrl+b” on switch boot up until the switch enters BootROM monitor mode. The operation result is shown

below:

[Boot]:

Step 3:

Under BootROM mode, run “setconfig” to set the IP address and mask of the switch under BootROM mode,

server IP address and mask, and select TFTP or FTP upgrade. Suppose the switch address is 192.168.1.2,

and PC address is 192.168.1.66, and select TFTP upgrade, the configuration should like:

[Boot]: setconfig

Host IP Address: [10.1.1.1] 192.168.1.2

Server IP Address: [10.1.1.2] 192.168.1.66

FTP(1) or TFTP(2): [1] 2

Network interface configure OK.

[Boot]

Step 4:

Enable FTP/TFTP server in the PC. For TFTP, run TFTP server program; for FTP, run FTP server program.

Before start downloading upgrade file to the switch, verify the connectivity between the server and the switch

by ping from the server. If ping succeeds, run “load” command in the BootROM mode from the switch; if it fails,

perform troubleshooting to find out the cause. The following is the configuration for the system update image

cable

connection

Console cable

connection

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 720 721

Comments to this Manuals

No comments

Planet XGS3-24042 User Manual Page 68

Comments to this Manuals

Related products and manuals for Routers Planet XGS3-24042