Planet XGS3-24042 User Manual Page 210

  • Download
  • Add to my manuals
  • Print
  • Page
    / 721
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 209
22-47
22.5.3 ARP Troubleshooting
If ping from the switch to directly connected network devices fails, the following can be used to check the
possible cause and create a solution.
Check whether the corresponding ARP has been learned by the switch.
If ARP has not been learned, then enabled ARP debugging information and view the sending/receiving
condition of ARP packets.
Defective cable is a common cause of ARP problems and may disable ARP learning.
22.6 Hardware Tunnel Capacity Configuration
22.6.1 Introduction to Hardware Tunnel Capacity
Hardware Tunnel Capacity is the maximum number of tunnel and MPLS forwarded by hardware. Capacity
can be adjusted by this command, increasing capacity will reduce hardware routing number supported by
switch, vice versa.
22.6.2 Hardware Tunnel Capacity Configuration
Hardware Tunnel Capacity Configuration Task List:
1. Configure hardware tunnel capacity
1. Configure hardware tunnel capacity
Command
Explanation
Global mode
hardware tunnel-capacity < size>
no hardware tunnel-capacity
Configure capacity of hardware tunnel and
MPLS, the no command restores the default
capacity.
Note: after adjust hardware tunnel capacity, it needs to reset switch to enable the valid configuration.
22.6.3 Hardware Tunnel Capacity Troubleshooting
After adjust hardware tunnel capacity, it must save the configuration and reset switch, the configuration
can takes effect.
Page view 209
1 2 ... 205 206 207 208 209 210 211 212 213 214 215 ... 720 721

Comments to this Manuals

No comments