Planet XGS3-24042 User Manual download pdf (Page 36)

100

101

2-7

Connection to the Managed Switch requires UTP Category 5 network cabling with RJ-

tips. For more information, please see the Cabling Specification in Appendix A.

Step5: Supply power to the Managed Switch.

Connect one end of the power cable to the Managed Switch.

Connect the power plug of the power cable to a standard wall outlet.

When the Managed Switch receives power, the Power LED should remain solid Green.

2.2.2 Rack Mounting

To install the Managed Switch in a 19-inch standard rack, please follows the instructions described below.

Step1: Place the Managed Switch on a hard flat surface, with the front panel positioned towards the front

side.

Step2: Attach the rack-mount bracket to each side of the Managed Switch with supplied screws attached to

the package.

Figure 2-2-2 shows how to attach brackets to one side of the Managed Switch.

Figure 2-2-2 Attach brackets to the Managed Switch.

You must use the screws supplied with the mounting brackets. Damage caused to the

parts by using incorrect screws would invalidate the warranty.

Step3: Secure the brackets tightly.

Step4: Follow the same steps to attach the second bracket to the opposite side.

Step5: After the brackets are attached to the Managed Switch, use suitable screws to securely attach the

brackets to the rack, as shown in Figure 2-2-3.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 720 721

Comments to this Manuals

No comments

Planet XGS3-24042 User Manual Page 36

Comments to this Manuals

Related products and manuals for Routers Planet XGS3-24042