Planet XGS3-24042 User Manual Page 411

  • Download
  • Add to my manuals
  • Print
  • Page
    / 721
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 410
48-10
1. Enable PIM-SM Protocol
The PIM-SM protocol can be enabled on XGS3 series Layer 3 switches by enabling PIM in global
configuration mode and then enabling PIM-SM for specific interfaces in the interface configuration mode.
Command
Explanation
Global Mode
ip pim multicast-routing
To enable the PIM-
SM protocol for all the
interfaces (However, in order to make PIM-SM
work for specific interfaces, the following
command should be issued).(Required)
And then turn on PIM-SM switch on the interface
Command
Explanation
Interface Configuration Mode
ip pim sparse-mode
Enable PIM-
SM Protocol of the interface.
(Required).
2. Configure static multicast routing entries
Command
Explanation
Global Configuration Mode
ip mroute <A.B.C.D> <A.B.C.D>
<ifname> <.ifname>
no ip mroute <A.B.C.D>
<A.B.C.D> [<ifname> <.ifname>]
To configure a static multicast routing entry. The
no form of this command will remove the
specified static multicast routing entry.
3. Configure additional parameters for PIM-SM
(1) Configure parameters for PIM-SM interfaces
1) Configure the interval for PIM-SM hello messages
Command
Explanation
Interface Configuration Mode
ip pim hello-interval <interval>
no ip pim hello-interval
To configure the interval for PIM-
SM hello
messages. The no form of this command
restores the interval to the default value.
2) Configure the hold time for PIM-SM hello messages
Command
Explanation
Interface Configuration Mode
Page view 410
1 2 ... 406 407 408 409 410 411 412 413 414 415 416 ... 720 721

Comments to this Manuals

No comments