Planet XGS3-24042 User Manual Page 472

  • Download
  • Add to my manuals
  • Print
  • Page
    / 721
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 471
49-16
RP1 Configuration:
Switch#config
Switch(config)#interface loopback 1
Switch(Config-if-Loopback1)#ipv6 address 2006::1/128
Switch(Config-if-Loopback1)#exit
Switch(config)#ipv6 pim rp-candidate loopback1
Switch(config)#ipv6 pim bsr-candidate vlan 1
Switch(config)#ipv6 pim multicast-routing
Switch(config)#ipv6 pim anycast-rp
Switch(config)#ipv6 pim anycast-rp self-rp-address 2003::1
Switch(config)#ipv6 pim anycast-rp 2006::1 2004::2
RP2 Configuration:
Switch#config
Switch(config)#interface loopback 1
Switch(Config-if-Loopback1)#ipv6 address 2006::1/128
Switch(Config-if-Loopback1)#exit
Switch(config)#ipv6 pim rp-candidate loopback1
Switch(config)#ipv6 pim multicast-routing
Switch(config)#ipv6 pim anycast-rp
Switch(config)#ipv6 pim anycast-rp self-rp-address 2004::2
Switch(config)#ipv6 pim anycast-rp 2006::1 2003::1
Please pay attention to that, for promulgating loopback interface router, if use MBGP4+ protocol, then can use
network command; or use RIPng protocol, then can use route command.
49.3.4 ANYCAST RP v6 Troubleshooting
When configuring and using ANYCAST RP v6 function, the ANYCAST RP might work abnormally because of
faults in physical connections, configurations or something others. So, the users should pay attention to the
following points:
The physical connections should be guaranteed to be correct
The PIM-SM6 protocol should be guaranteed to operate normally
The ANYCAST RP should be guaranteed to be enabled in Global configuration mode
The self-rp-address should be guaranteed to be configured correctly in Global configuration mode
The other-rp-address should be guaranteed to be configured correctly in Global configuration mode
All the interface routers should be guaranteed to be correctly added, including the loopback interface as
a RP
Use “show ipv6 pim anycast rp status” command to check whether the configuration information of
ANYCAST RP is correct
If the problems of ANYCAST still cannot be solved after checking, please use debug commands like “debug
ipv6 pim anycast-rp”, then copy the DEBUG information within three minutes and send it to the technical
service center of our company.
Page view 471
1 2 ... 467 468 469 470 471 472 473 474 475 476 477 ... 720 721

Comments to this Manuals

No comments