Planet XGS3-24042 User Manual Page 430

  • Download
  • Add to my manuals
  • Print
  • Page
    / 721
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 429
48-29
Switch(config)#ip pim rp-candidate loopback1
Switch(config)#ip pim bsr-candidate vlan 1
Switch(config)#ip pim multicast-routing
Switch(config)#ip pim anycast-rp
Switch(config)#ip pim anycast-rp self-rp-address 192.168.2.1
Switch(config)#ip pim anycast-rp 1.1.1.1 192.168.3.2
RP2 Configuration:
Switch#config
Switch(config)#interface loopback 1
Switch(Config-if-Loopback1)#ip address 1.1.1.1 255.255.255.255
Switch(Config-if-Loopback1)#exit
Switch(config)#ip pim rp-candidate loopback1
Switch(config)#ip pim multicast-routing
Switch(config)#ip pim anycast-rp
Switch(config)#ip pim anycast-rp self-rp-address 192.168.3.2
Switch(config)#ip pim anycast-rp 1.1.1.1 192.168.2.1
48.5.4 ANYCAST RP Troubleshooting
When configuring and using ANYCAST RP function, the ANYCAST RP might work abnormally because of
faults in physical connections, configurations or something others. So, the users should pay attention to the
following points:
The physical connections should be guaranteed to be correct
The PIM-SM protocol should be guaranteed to operate normally
The ANYCAST RP should be guaranteed to be enabled in Global configuration mode
The self-rp-address should be guaranteed to be configured correctly in Global configuration mode
The other-rp-address should be guaranteed to be configured correctly in Global configuration mode
All the interface routers should be guaranteed to be correctly added, including the loopback interface
as a RP
Use “show ip pim anycast rp status” command to check whether the configuration information of
ANYCAST RP is correct
If the problems of ANYCAST still cannot be solved after checking, please use debug commands like “debug
pim anycast-rp”, then copy the DEBUG information within three minutes and send it to the technical service
center of our company.
48.6 PIM-SSM
48.6.1 Introduction to PIM-SSM
Page view 429
1 2 ... 425 426 427 428 429 430 431 432 433 434 435 ... 720 721

Comments to this Manuals

No comments