Planet XGS3-24042 User Manual download pdf (Page 670)

100

101

80-24

The LDP configuration of P is as follows:

P#config

P(config)#mpls enable

P(config)# router ldp

P(config-router)#exit

P(config)#interface vlan 1

P(config-if-Vlan1)#ip address 202.200.1.1 255.255.255.0

P(config-if-Vlan1)#ldp enable

P(config-if-Vlan1)#label-switching

P(config-if-Vlan1)#exit

P(config)#interface vlan 2

P(config-if-Vlan2)#ip address 202.200.2.1 255.255.255.0

P(config-if-Vlan2)#ldp enable

P(config-if-Vlan2)#label-switching

P(config-if-Vlan2)#exit

P(config)#router ospf

P(config-router)#network 202.200.1.0/24 area 0

P(config-router)#network 202.200.2.0/24 area 0

P(config-router)#exit

The LDP configuration of PE2 is as follows:

PE2#config

PE2(config)#mpls enable

PE2(config)# router ldp

PE2(config-router)#exit

PE2(config)#interface vlan 3

PE1(config-if-Vlan3)#ip address 202.200.2.2 255.255.255.0

PE2(config-if-Vlan3)#ldp enable

PE2(config-if-Vlan3)#label-switching

PE2(config-if-Vlan3)#exit

PE2(config)#router ospf

PE2(config-router)#network 200.200.1.2/32 area 0

PE2(config-router)#network 202.200.2.0/24 area 0

PE2(config-router)#exit

Please refer to BGP VPN typical instances for the configuration of BGP.

80.4 LDP Troubleshooting

When configuring and using LDP, some problems like incorrect physical connections, configuration errors

may cause it to fail, so plesase pay attention to the following notices to avoid them:

 First, make sure the system enables LDP globally and on the active interface. Notice that the LDP

can only be enabled on interfaces after it is enabled globally.

1 2 ... 665 666 667 668 669 670 671 672 673 674 675 ... 720 721

Comments to this Manuals

No comments

Planet XGS3-24042 User Manual Page 670

Comments to this Manuals

Related products and manuals for Routers Planet XGS3-24042