Planet XGS3-24042 User Manual download pdf (Page 291)

100

101

36-9

exit-address-family

This command exits the address family mode.

36.3 RIP Examples

36.3.1 Typical RIP Examples

Figure 36-1 RIP example

In the figure shown above, a network consists of three Layer 3 switches, in which SwitchA connected with

SwitchB and SwitchC, and RIP routing protocol is running in all of the three switches. SwitchA （interface

vlan1：10.1.1.1,interface vlan2：20.1.1.1）exchanges Layer 3 switch update messages only with SwitchB

（interface vlan1：10.1.1.2）, but not with SwitchC（interface vlan 2: 20.1.1.2）.

SwitchA, SwitchB, SwitchC configurations are as follows:

a) Layer 3 SwitchA：

Configure the IP address of interface vlan 1

SwitchA#config

SwitchA(config)# interface vlan 1

SwitchA(Config-if-Vlan1)# ip address 10.1.1.1 255.255.255.0

SwitchA(config-if-Vlan1)#

Configure the IP address of interface vlan 2

SwitchA(config)# vlan 2

SwitchA(Config-Vlan2)# switchport interface ethernet 1/0/2

Set the port Ethernet1/0/1 access vlan 2 successfully

SwitchA(Config-Vlan2)# exit

SwitchA(config)# interface vlan 2

SwitchA(Config-if-Vlan2)# ip address 20.1.1.1 255.255.255.0

Initiate RIP protocol and configure the RIP segments

SwitchA(config)#router rip

SwitchA(config-router)#network vlan 1

SwitchA(config-router)#network vlan 2

SwitchA(config-router)#exit

SWITCHA

SWITCHB

SWITCHC

Interface

vlan1:10.1.1.1/24

Interface

vlan1:10.1.1.2/24

Interface

vlan2:20.1.1.1/24

Interface

vlan1:20.1.1.2/24

1 2 ... 286 287 288 289 290 291 292 293 294 295 296 ... 720 721

Comments to this Manuals

No comments

Planet XGS3-24042 User Manual Page 291

Comments to this Manuals

Related products and manuals for Routers Planet XGS3-24042