GEPON OLTEPL-1000Quick Installation Guide
10Step 2. Power ConnectionsAC Power ConnectionConnect the AC power cord to the AC supply socket on the rear panel of the OLT, and plug the
11Mini-GBIC (SFP) InterfacePrepare a proper SFP module and install it into the optical trunk port. Then you can connect ber optics cabling that uses
12Step 4. Connecting the PON InterfacePON ConnectionThe system supports one xed PON port, the max. Split ratio is up to 1:32 per PON
134.2 Software SetupThis section illustrates how to establish basic connectivity on the PON. After completing this section the user wi
14EPL-1000 GUI Personality SetupThe EPL-1000 supports a 10/100Mb Management interface for User-Friendly GUI Management. Prior to installin
15MGMT Port – Static IP AddressesIf you are controlling the EPON system from a local PC connected directly to the management port, the
163) Once you have connected all of the hardware, followed the instructions in the Initial Power Up section, set the personality ash to s
175. Application5.1 GEPON ApplicationsThe OLT device is deployed in the central ofce room. The ONU devices are connected to the OLT devi
185.2 FTTx Applications (FTTH / FTTB)IPTVVoIPInternetGEPON OLT1000Base-T UTP100Base-TX UTPPONPassive Optical NetworkCommunityHigh Rise BuildingsPCCame
19Further informationThe above steps introduce simple installations and congurations for EPL-1000. For further congurations and informa
Table of Contents1. Introduction ... 32. Package Content
This page is intentionally left blank
31. IntroductionEPON is a point to multipoint communications protocol based on Gigabit Ethernet. It allows a Gigabit Ethernet communic
42 Package ContentsEPL-1000EPL-1000 Unit x 1AC Power Cord x 1Quick Installation Guide x 1CD (Containing User’s Manual, QIG, Utility) x 1Console Cable
53. OverviewFront PanelThe front panel of EPL-1000 is shown below.EPL-1000Front Panel LED and Port denitionLED Status DescriptionPWROn The indicator
6StatusALM1Glitter There will be one ONU or OLT alarmOff Normal work statusALM2Glitter There will be one ONU or OLT alarmOff Normal work statusALM3Gli
74. Setup the GEPON OLT EPL-1000The followings are instructions for setting up PLANET EPL-1000. Refer to the illustration and follow the si
8Installation OverviewThe installation consists of the following procedures. Each procedure will be explained in detail in the following sec
9After the site requirements have been veried, the chassis may be installed at the specied location. When mounting the chassis, practice
Comments to this Manuals