Planet XGS3-24042 User Manual download pdf (Page 115)

100

101

12-7

Configuration result:

Add ports 1, 2, 3, 4 of S1 to port-group1 in order, and we can see a group in “on” mode is completely joined

forcedly, switch in other ends won’t exchange LACP PDU to complete aggregation. Aggregation finishes

immediately when the command to add port 2 to port-group 1 is entered, port 1 and port 2 aggregate to be

port-channel 1, when port 3 joins port-group 1, port-channel 1 of port 1 and 2 are ungrouped and re-aggregate

with port 3 to form port-channel 1, when port 4 joins port-group 1, port-channel 1 of port 1, 2 and 3 are

ungrouped and re-aggregate with port 4 to form port-channel 1. (It should be noted that whenever a new port

joins in an aggregated port group, the group will be ungrouped first and re-aggregated to form a new group.)

Now all four ports in both S1 and S2 are aggregated in “on” mode and become an aggregated port

respectively.

12.5 Port Channel Troubleshooting

If problems occur when configuring port aggregation, please first check the following for causes.

 Ensure all ports in a port group have the same properties, i.e., whether they are in full-duplex mode,

forced to the same speed, and have the same VLAN properties, etc. If inconsistency occurs, make

corrections.

 Some commands cannot be used on a port in port-channel, such as arp, bandwidth, ip, ip-forward, etc.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 720 721

Comments to this Manuals

No comments

Planet XGS3-24042 User Manual Page 115

Comments to this Manuals

Related products and manuals for Routers Planet XGS3-24042