Planet XGS3-24042 User Manual download pdf (Page 90)

100

101

7-4

The configurations are listed below:

Switch1:

Switch1(config)#interface ethernet 1/0/7

Switch1(Config-If-Ethernet1/0/7)#bandwidth control 50 both

Switch2:

Switch2(config)#interface ethernet 1/0/9

Switch2(Config-If-Ethernet1/0/9)#speed-duplex force100-full

Switch2(Config-If-Ethernet1/0/9)#exit

Switch2(config)#interface ethernet 1/0/10

Switch2(Config-If-Ethernet1/0/10)#speed-duplex force1g-full

Switch2(Config-If-Ethernet1/0/10)#exit

Switch2(config)#monitor session 1 source interface ethernet1/0/8;1/0/9

Switch2(config)#monitor session 1 destination interface ethernet 1/0/10

Switch3:

Switch3(config)#interface ethernet 1/0/12

Switch3(Config-If-Ethernet1/0/12)#speed-duplex force100-full

Switch3(Config-If-Ethernet1/0/12)#exit

7.4 Port Troubleshooting

Here are some situations that frequently occurs in port configuration and the advised solutions:

 Two connected fiber interfaces won’t link up if one interface is set to auto-negotiation but the other to

forced speed/duplex. This is determined by IEEE 802.3.

 The following combinations are not recommended: enabling traffic control as well as setting multicast

limiting for the same port; setting broadcast, multicast and unknown destination unicast control as well

as port bandwidth limiting for the same port. If such combinations are set, the port throughput may fall

below the expected performance.

 For Combo port, it supports copper-forced mode and sfp-forced mode (default mode), here, copper port

will not be up.

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 720 721

Comments to this Manuals

No comments

Planet XGS3-24042 User Manual Page 90

Comments to this Manuals

Related products and manuals for Routers Planet XGS3-24042