Planet XGS3-24042 User Manual download pdf (Page 303)

100

101

37-9

Figure 37-2 Typical application of RIPng aggregation

As the above network topology, S2 is connected to S1 through interface vlan1, there are other 4 subnet

routers of S2, which are 2001:1::20:0/112, 2001:1::21:0/112, 2001:1::22:0/112, 2001:1::23:0/112. S2 supports

route aggregation, and to configure aggregation route 2001:1::20:0/110 in interface vlan1 of S2, after that,

sending router messages to S2 through vlan1, and put the four subnet routers aggregated to one router as

2001:1::20:0/110, and send to S1, and not send subnet to neighbor. It can reduce the router table of S1, save

the memory.

S1 configuration list:

S1(config)#router ipv6 rip

S1(config-router) #network vlan 1

S2 configuration list:

S2(config)#router ipv6 rip

S2(config-router) #network vlan 1

S2(config-router) #exit

S2(config)#in vlan 1

S2(Config-if-Vlan1)# ipv6 rip agg 2001:1::20:0/110

37.4 RIPng Troubleshooting

The RIPng protocol may not be working properly due to errors such as physic connection, configuration error

when configuring and using the RIPng protocol. So users should pay attention to the following:

 First ensure the physic connection is correct and the IP Forwarding command is open

 Second, ensure the interface and link layer protocol are UP (use show interface command)

 Then initiate the RIPng protocol (use router IPv6 rip command) and configure the port (use IPv6

router command), and set RIPng protocol parameter on corresponding interfaces.

 After that, a RIPng protocol feature should be noticed ---the Layer 3 switch running RIPng transmits the

VLAN1

2001:1::1:1

VLAN1

2001:1::1:2

2001:1::20:0/110

2001:1::20:0/112

2001:1::21:0/112

2001:1::22:0/112

2001:1::23:0/112

1 2 ... 298 299 300 301 302 303 304 305 306 307 308 ... 720 721

Comments to this Manuals

No comments

Planet XGS3-24042 User Manual Page 303

Comments to this Manuals

Related products and manuals for Routers Planet XGS3-24042