Planet XGS3-24042 User Manual download pdf (Page 531)

100

101

52-17

# Set the access control mode on the port as portbased.

Switch(Config-If-Ethernet1/0/2)#dot1x port-method portbased

# Set the access control mode on the port as auto.

Switch(Config-If-Ethernet1/0/2)#dot1x port-control auto

# Set the port’s Guest VLAN as 100.

Switch(Config-If-Ethernet1/0/2)#dot1x guest-vlan 100

Switch(Config-If-Ethernet1/0/2)#exit

Using the command of show running-config or show interface ethernet 1/2, users can check the

configuration of Guest VLAN. When there is no online user, no failed user authentication or no user gets

offline successfully, and more authentication-triggering messages (EAP-Request/Identity) are sent than the

upper limit defined, users can check whether the Guest VLAN configured on the port takes effect with the

command show vlan id 100.

52.3.2 Examples of IPv4 Radius Applications

Figure

52-16 IEEE 802.1x Configuration Example Topology

The PC is connecting to port 1/0/2 of the switch; IEEE 802.1x authentication is enabled on port1/0/2; the

access mode is the default MAC-based authentication. The switch IP address is 10.1.1.2. Any port other than

port 1/0/2 is used to connect to RADIUS authentication server, which has an IP address of 10.1.1.3, and use

the default port 1812 for authentication and port 1813 for accounting. IEEE 802.1x authentication client

software is installed on the PC and is used in IEEE 802.1x authentication.

10.1.1.1

10.1.1.2

Radius Server

10.1.1.3

1 2 ... 526 527 528 529 530 531 532 533 534 535 536 ... 720 721

Comments to this Manuals

No comments

Planet XGS3-24042 User Manual Page 531

Comments to this Manuals

Related products and manuals for Routers Planet XGS3-24042