Planet XGS3-24042 User Manual Page 464

  • Download
  • Add to my manuals
  • Print
  • Page
    / 721
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 463
49-8
ipv6 mroute <X:X::X:X>
<X:X::X:X> <ifname> <.ifname>
no ipv6 mroute <X:X::X:X>
<X:X::X:X> [<ifname> <.ifname>]
To configure a static multicast routing entry. The
no form of this command will remove the
specified static multicast routing entry.
3. Configure the additional parameters for PIM-SM
1Configure parameters for PIM-SM interfaces
1) Configure the interval for PIM-SM hello messages
Command
Explanation
Interface Configuration Mode
ipv6 pim hello-interval <interval>
no ipv6 pim hello-interval
To configure the interval for PIM-SM hello
messages. The no form of this command
restores the interval to the default value.
2) Configure the hold time for PIM-SM6 hello messages
Command
Explanation
Interface Configuration Mode
ipv6 pim hello-holdtime <value>
no ipv6 pim hello-holdtime
To configure the value of the holdtime field in the
PIM-SM hello messages. The no form of this
command will restore the hold time to the default
value.
3) Configure ACL for PIM-SM6 neighbors
Command
Explanation
Interface Configuration Mode
ipv6 pim neighbor-filter
<acess-list-name>
no ipv6 pim neighbor-filter
<acess-list-name>
To configure ACL to filter PIM-SM6 neighbor. If
session to the neighbor has been denied by
ACL, then the sessions that have been set up
will be discarded immediately and new sessions
will not be set up.
4) Configure the interface as the boundary interface of the PIM-SM6 protocol
Command
Explanation
Interface Configuration Mode
ipv6 pim bsr-border
no ipv6 pim bsr-border
To configure the interface as the boundary of
PIM-SM6 protocol. On the boundary interface,
BSR messages will not be sent or received. The
network connected the interface is considered
as directly connected network. The no form of
this command will remove the configuration.
Page view 463
1 2 ... 459 460 461 462 463 464 465 466 467 468 469 ... 720 721

Comments to this Manuals

No comments