Planet XGS3-24042 User Manual Page 459

  • Download
  • Add to my manuals
  • Print
  • Page
    / 721
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 458
49-3
ipv6 pim dense-mode
To enable PIM-DM
for the specified interface
(required).
2Configure static multicast routing entries
Command
Explanation
Global configuration mode
ipv6 mroute <X:X::X:X>
<X:X::X:X> <ifname> <.ifname>
no ipv6 mroute <X:X::X:X>
<X:X::X:X> [<ifname> <.ifname>]
To configure IPv6 static multicast routing entries.
The no form of this command will remove the
specified routing entry.
3. Configure additional PIM-DM parameters
1Configure parameters for PIM-DM interfaces
1) Configure the interval for PIM-DM hello messages
Command
Explanation
Interface Configuration Mode
ipv6 pim hello-interval <interval>
no ipv6 pim hello-interval
To configure the interval for PIM-DM hello
messages. The no form of this command will
restore the default value.
2) Configure the interval for PIM-DM state-refresh messages
Command
Explanation
Interface Configuration Mode
ipv6 pim state-refresh
origination-interval
no ipv6 pim state-refresh
origination-interval
To configure the interval for sending PIM-DM
state-
refresh packets. The no form of this
command will restore the default value.
3) Configure the boundary interfaces
Command
Explanation
Interface Configuration Mode
ipv6 pim bsr-border
no ipv6 pim bsr-border
To configure the interface as the boundary of
PIM-DM6 protocol. On the boundary interface,
STATE REFRESH messages will not be sent or
received. The network connected the interface is
considered as directly connected network. The
no form of this command will remove the
configuration.
4) Configure the management boundary
Page view 458
1 2 ... 454 455 456 457 458 459 460 461 462 463 464 ... 720 721

Comments to this Manuals

No comments