Planet XGS3-24042 User Manual download pdf (Page 44)

100

101

3-15

The following describes the steps for a Telnet client to connect to the switch’s VLAN1 interface by Telnet(IPV4

address example):

Figure 3-6 Manage the switch by Telnet

Step 1: Configure the IP addresses for the switch and start the Telnet Server function on the switch.

First is the configuration of host IP address. This should be within the same network segment as the switch

VLAN1 interface IP address. Suppose the switch VLAN1 interface IP address is 10.1.128.251/24. Then, a

possible host IP address is 10.1.128.252/24. Run “ping 10.1.128.251” from the host and verify the result,

check for reasons if ping failed.

The IP address configuration commands for VLAN1 interface are listed below. Before in-band management,

the switch must be configured with an IP address by out-of-band management (i.e. Console mode), the

configuration commands are as follows (All switch configuration prompts are assumed to be “Switch”

hereafter if not otherwise specified):

itch>

Switch>en

able

Switch#config

Switch

(config)#interface vlan 1

Switch(

Config-if-Vlan1)#ip address 10.1.128.251 255.255.255.0

Switch(Config-if-Vlan1)#no shutdown

To enable the Telnet Server function, users should type the CLI command telnet-server enable in the global

mode as below:

Switch

>en

Switch#config

Switch(config)# telnet-server enable

Step 2: Run Telnet Client program.

Run Telnet client program included in Windows with the specified Telnet target.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 720 721

Comments to this Manuals

No comments

Planet XGS3-24042 User Manual Page 44

Comments to this Manuals

Related products and manuals for Routers Planet XGS3-24042