Planet XGS3-24042 User Manual download pdf (Page 439)

100

101

48-38

The next is to configure the rule of source control. It is configured in the same manner as for ACL, and uses

ACL number of 5000-5099, every rule number can be used to configure 10 rules. It is noticeable that these

rules are ordered, the front one is the one which is configured the earliest. Once the configured rules are

matched, the following rules won’t take effect, so rules of globally allow must be put at the end. The

commands are as follows:

Command

Explanation

Global Configuration Mode

[no] access-list <5000-5099>

{deny|permit} ip {{<source>

<source-wildcard>}|{host-source

<source-host-ip>}|any-source}

{{<destination>

<destination-wildcard>}|{host-desti

nation

<destination-host-ip>}|any-destinat

ion}

The rule used to configure source control. This

rule does not take effect until it is applied to

specified port. Using the NO form of it can delete

specified rule.

The last is to configure the configured rule to specified port.

Note: If the rules being configured will occupy the table entries of hardware, configuring too many rules will

result in configuration failure caused by bottom table entries being full, so we suggest user to use the simplest

rules if possible. The configuration rules are as follows:

Command

Explanation

Port Configuration Mode

[no] ip multicast source-control

access-group <5000-5099>

Used to configure the rules source control uses

to port, the NO form cancels the configuration.

2． Destination Control Configuration

Like source control configuration, destination control configuration also has three steps.

First, enable destination control globally. Since destination control need to prevent unauthorized user from

receiving multicast data, the switch won’t broadcast the multicast data it received after configuring global

destination control. Therefore, It should be avoided to connect two or more other Layer 3 switches in the

same VLAN on a switch on which destination control is enabled. The configuration commands are as follows:

Command

Explanation

Global Configuration Mode

1 2 ... 434 435 436 437 438 439 440 441 442 443 444 ... 720 721

Comments to this Manuals

No comments

Planet XGS3-24042 User Manual Page 439

Comments to this Manuals

Related products and manuals for Routers Planet XGS3-24042