Planet XGS3-24042 User Manual Page 406

  • Download
  • Add to my manuals
  • Print
  • Page
    / 721
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 405
48-5
48.2.2 PIM-DM Configuration Task List
1. Enable PIM-DM (Required)
2. Configure static multicast routing entries(Optional)
3. Configure additional PIM-DM parameters(Optional)
a) Configure the interval for PIM-DM hello messages
b) Configure the interval for state-refresh messages
c) Configure the boundary interfaces
d) Configure the management boundary
4. Disable PIM-DM protocol
1. Enable the PIM-DM protocol
When configuring the PIM-DM protocol on XGS3 series Layer 3 switches, PIM multicasting should be enabled
globally, then PIM-DM can be enabled for specific interfaces.
Command
Explanation
Global Mode
ip pim multicast-routing
no ip pim multicast-routing
To enable PIM-DM globally for all the interfaces
(However, in order to make PIM-
DM work for
specific interfaces, the following command
should be issued).
And then turn on PIM-SM switch on the interface
Command
Explanation
Interface Configuration Mode
ip pim dense-mode
To enable PIM-
DM protocol for the specified
interface.(Required)
2. Configure static multicast routing entries
Command
Explanation
Global Configuration Mode
ip mroute <A.B.C.D> <A.B.C.D>
<ifname> <.ifname>
no ip mroute <A.B.C.D>
<A.B.C.D> [<ifname> <.ifname>]
To configure a static multicast routing entry. The
no form of this command will remove the
specified entry.
3. Configure additional PIM-DM parameters
a) Configure the interval for PIM-DM hello messages
Command
Explanation
Interface Configuration Mode
Page view 405
1 2 ... 401 402 403 404 405 406 407 408 409 410 411 ... 720 721

Comments to this Manuals

No comments