Planet XGS3-24042 User Manual download pdf (Page 308)

100

101

38-4

38.2 OSPF Configuration Task List

The OSPF configuration for XGS3 series switches may be different from the configuration procedure to

switches of the other manufacturers. It is a two-step process:

1、 Enable OSPF in the Global Mode;2、Configure OSPF area for the interfaces. The configuration task

list is as follows:

1. Enable OSPF protocol (required)

(1) Enable/disable OSPF protocol (required)

(2) Configure the ID number of the layer3 switch running OSPF (optional)

(3) Configure the network scope for running OSPF (optional)

(4) Configure the area for the interface (required)

2. Configure OSPF protocol parameters (optional)

(1) Configure OSPF packet sending mechanism parameters

1) Configure OSPF packet verification

2) Set the OSPF interface to receive only

3) Configure the cost for sending packets from the interface

4) Configure OSPF packet sending timer parameter (timer of broadcast interface sending

HELLO packet to poll, timer of neighboring layer3 switch invalid timeout, timer of LSA

transmission delay and timer of LSA retransmission.

(2) Configure OSPF route introduction parameters

1) Configure default parameters (default type, default tag value, default cost)

2) Configure the routes of the other protocols to introduce to OSPF.

(3) Configure OSPF importing the routes of other OSPF processes

1) Enable the function of OSPF importing the routes of other OSPF processes

2) Display relative information

3) Debug

(4) Configure other OSPF protocol parameters

1) Configure OSPF routing protocol priority

2) Configure cost for OSPF STUB area and default route

3) Configure OSPF virtual link

4) Configure the priority of the interface when electing designated layer3 switch (DR).

5) Configure to keep a log for OSPF adjacency changes or not

3. Disable OSPF protocol

1. Enable OSPF protocol

Basic configuration of OSPF routing protocol on switch is quite simple, usually only enabling OSPF and

configuration of the OSPF area for the interface are required. The OSPF protocol parameters can use the

default settings. If OSPF protocol parameters need to be modified, please refer to “2. Configure OSPF

protocol parameters”.

Command

Explanation

Global Mode

1 2 ... 303 304 305 306 307 308 309 310 311 312 313 ... 720 721

Comments to this Manuals

No comments

Planet XGS3-24042 User Manual Page 308

Comments to this Manuals

Related products and manuals for Routers Planet XGS3-24042