Planet XGS3-24042 User Manual download pdf (Page 306)

38-2

One major advantage of link-state routing protocols is the fact that infinite counting is impossible, this is

because of the way link-state routing protocols build up their routing table. The second advantage is that

converging in a link-state interconnected network is very fast, once the routing topology changes, updates will

be flooded throughout the network very soon. Those advantages release some layer3 switch resources, as

the process ability and bandwidth used by bad route information are minor.

The features of OSPF protocol include the following: OSPF supports networks of various scales, several

hundreds of layer3 switches can be supported in an OSPF network. Routing topology changes can be quickly

found and updating LSAs can be sent immediately, so that routes converge quickly. Link-state information is

used in shortest path algorithm for route calculation, eliminating loop route. OSPF divides the autonomous

system into areas, reducing database size, bandwidth occupation and calculation load. (According to the

position of layer3 switches in the autonomous system, they can be grouped as internal area switches, area

border switches, AS border switches and backbone switches). OSPF supports load balance and multiple

routes to the same destination of equal costs. OSPF supports 4 level routing mechanisms (process routing

according to the order of intra-area path, inter-area path, type 1 external path and type 2 external path). OSPF

supports IP subnet and redistribution of routes from the other routing protocols, and interface-based packet

verification. OSPF supports sending packets in multicast.

Each OSPF layer3 switch maintains a database describing the topology of the whole autonomous system.

Each layer3 switch gathers the local status information, such as available interface, reachable neighbors, and

sends link-state advertisement (sending out link-state information) to exchange link-state information with

other OSPF layer3 switches to form a link-state database describing the whole autonomous system. Each

layer3 switch builds a shortest path tree rooted by itself according to the link-state database, this tree provides

the routes to all nodes in an autonomous system. If two or more layer3 switches exist (i.e. multi-access

network), "designated layer3 switch” and “backup designated layer3 switch” will be selected. Designated

layer3 switch is responsible for spreading link-state of the network. This concept helps reducing the traffic

among the Layer3 switches in multi-access network.

OSPF protocol requires the autonomous system to be divided into areas. That is to divide the autonomous

system into 0 area (backbone area) and non-0 areas. Routing information between areas are further

abstracted and summarized to reduce the bandwidth required in the network. OSPF uses four different kinds

of routes; they are intra-area route, inter-area route, type 1 external route and type 2 external route, in the

order of highest priority to lowest. The route inside an area and between areas describes the internal network

structure of an autonomous system, while external routes describe how to select the routing information to

destination outside the autonomous system. The first type of exterior route corresponds to the information

introduced by OSPF from the other interior routing protocols, the costs of those routes are comparable with

the costs of OSPF routes; the second type of exterior route corresponds to the information introduced by

OSPF from the other exterior routing protocols, but the costs of those routes are far greater than that of OSPF

routes, so OSPF route cost is ignored when calculating route costs.

OSPF areas are centered with the Backbone area, identified as Area 0, all the other areas must be connected

to Area 0 logically, and Area 0 must be continuous. For this reason, the concept of virtual link is introduced to

the backbone area, so that physically separated areas still have logical connectivity to the backbone area.

The configurations of all the layer3 switches in the same area must be the same.

1 2 ... 301 302 303 304 305 306 307 308 309 310 311 ... 720 721

No comments

Planet XGS3-24042 User Manual Page 306