Planet ADW-4401 User Manual download pdf (Page 62)

The following table describes the parameters and buttons of this page:

Field Description

Direction Select

Select the router interface. You can select LAN or WAN.

In this example, WAN is selected.

WAN Setting You can choose Interface or IP Address.

WAN Interface

Choose the interface that permits data packets from

WAN to access the router.

IP Address

Enter the IP address on the WAN. Only the IP address

that is in the same network segment with the IP address

on the WAN can access the router.

Services Allowed

You can choose the following services from WAN: web,

telnet, ftp, tftp, snmp, or ping. You can also choose all

the services.

Add

After setting the parameters, click it to add an entry to

the Current ACL Table.

Reset Click it to refresh this page.

3.6 Advance

In the navigation bar, click Advance. In the Advance page that is displayed contains

Bridge Setting, Routing, QoS, SNMP and Others.

3.6.1 Bridge Setting

Choose Advance > Bridge Setting, the page shown in the following figure appears. This

page is used to configure the bridge parameters. You can change the settings or view

some information on the bridge and its attached ports.

The following table describes the parameters and button of this page:

Field Description

Aging Time

If the host is idle for 300 seconds (default

value), its entry is deleted from the bridge table.

802.1d Spanning Tree

You can select Disabled or Enabled.

Select Enabled to provide path redundancy

while preventing undesirable loops in your

network.

Show MACs

Click it to show a list of the learned MAC

addresses for the bridge.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 83 84

No comments

Planet ADW-4401 User Manual Page 62