Planet ADW-4401 User Manual download pdf (Page 42)

The following table describes the parameters and buttons of this page:

Field Description

Protocol

It displays the protocol type used for this WAN

connection.

ATM VCC

The ATM virtual circuit connection assigned for this PPP

interface (VPI/VCI).

Password The password provided by your ISP.

Authentication

Method

You can choose AUTO, CHAP, or PAP.

Connection Type

You can choose Continuous, Connect on Demand, or

Manual.

Idle Time (s)

If choose Connect on Demand, you need to enter the

idle timeout time. Within the preset minutes, if the router

does not detect the flow of the user continuously, the

router automatically disconnects the PPPoE connection.

Bridge

You can select Bridged Ethernet, Bridged PPPoE, or

Disable Bridge.

AC-Name The accessed equipment type.

Service-Name The service name.

802.1q

You can select Disable or Enable. After enable it, you

need to enter the VLAN ID. The value ranges from 0 to

4095.

Apply Changes Click it to save the settings of this page temporarily.

Return Click it to return to the Channel Configuration page.

Undo Click it to refresh this page.

3.4.2.2 ATM Setting

Click ATM Setting in the left pane, the page shown in the following figure appears. In this

page, you can configure the parameters of the ATM, including QoS, PCR, CDVT, SCR,

and MBS.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 83 84

No comments

Planet ADW-4401 User Manual Page 42