Planet ADW-4401 User Manual download pdf (Page 40)

3.4.2.1 WAN

Click WAN in the left pane, the page shown in the following figure appears.

In this page, you can configure WAN interface of your router.

The following table describes the parameters of this page:

Field Description

Default Route Selection You can select Auto or Specified.

VPI

The virtual path between two points in an ATM network,

ranging from 0 to 255.

VCI

The virtual channel between two points in an ATM

network, ranging from 32 to 65535 (1 to 31 are reserved

for known protocols)

Encapsulation You can choose LLC and VC-Mux.

Channel Mode

You can choose 1483 Bridged, 1483 MER, PPPoE,

PPPoA, or 1483 Routed.

Enable NAPT

Select it to enable Network Address Port Translation

(NAPT) function. If you do not select it and you want to

access the Internet normally, you must add a route on the

uplink equipment. Otherwise, the access to the Internet

fails. Normally, it is enabled.

Enabel IGMP

You can enable or disable Internet Group Management

Protocol (IGMP) function.

PPP Settings

User Name

Enter the correct user name for PPP dial-up, which is

provided by your ISP.

Password

Enter the correct password for PPP dial-up, which is

provided by your ISP.

Type

You can choose Continuous, Connect on Demand, or

Manual.

Idle Time (min)

If set the type to Connect on Demand, you need to enter

the idle timeout time. Within the preset minutes, if the

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 83 84

No comments

Planet ADW-4401 User Manual Page 40