Planet WGSW-20160HP User Manual Page 95
- Page / 555
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
User’s Manual of WGSW-20160HP
Wave Length(nm)
Display the wavelength of current SFP module, the wavelength value is get from
the SFP module. Use this column to check if the wavelength values of two nodes
are the matched while the fiber connection is failed.
Distance(m)
Display the supports distance of current SFP module, the distance value is get
from the SFP module.
Buttons
Auto-refresh : Check this box to enable an automatic refresh of the Page at regular intervals.
: Click to refresh the Page immediately.
4.4.5 Port Mirror
Configure port Mirroring on this Page. This function provide to monitoring network traffic that forwards a copy of each incoming
or outgoing packet from one port of a network Switch to another port where the packet can be studied. It enables the manager to
keep close track of switch performance and alter it if necessary.
To debug network problems, selected traffic can be copied, or mirrored, to a mirror port where a frame analyzer can be
attached to analyze the frame flow.
The Managed Switch can unobtrusively mirror traffic from any port to a monitor port. You can then attach a protocol
analyzer or RMON probe to this port to perform traffic analysis and verify connection integrity.
Figure 4-4-5: Port Mirror Application
95
- TABLE OF CONETNTS 3
- 1. INTRODUTION 21
- 1.3 How to Use This Manual 24
- 1.4 Product Features 25
- 1.5 Product Specification 28
- 2. INSTALLATION 31
- 2.1.2 LED Indications 32
- 2.1.3 Switch Rear Panel 33
- 2.2 Install the Switch 34
- 2.2.2 Rack Mounting 35
- 3. SWITCH MANAGEMENT 39
- 3.3 Administration Console 40
- Direct Access 41
- 3.4 Web Management 42
- 4. WEB CONFIGURATION 45
- 4.1 Main Web Page 48
- 4.2 System 50
- 4.2.1 System Information 51
- 4.2.2 IP Configuration 52
- 4.2.3 IPv6 Configuration 53
- 4.2.4 Users Configuration 54
- Add / Edit User 55
- 4.2.5 Privilege Levels 57
- 4.2.6 NTP Configuration 59
- 4.2.7 UPnP 60
- 4.2.8 DHCP Relay 61
- 4.2.9 DHCP Relay Statistics 63
- 4.2.10 CPU Load 65
- 4.2.11 System Log 66
- 4.2.12 Detailed Log 67
- 4.2.13 Remote Syslog 68
- 4.2.14 SMTP Configuration 69
- 4.2.15 Web Firmware Upgrade 70
- 4.2.16 TFTP Firmware Upgrade 71
- 4.2.17 Configuration Backup 71
- 4.2.18 Configuration Upload 74
- 4.2.19 Image Select 75
- 4.2.20 Factory Default 76
- 4.2.21 System Reboot 77
- 4.3.1 SNMP Overview 78
- 4.3.5 SNMPv3 Configuration 83
- 4.4 Port Management 89
- 4.4.3 Port Statistics Detail 92
- 4.4.4 SFP Information 94
- 1000Base-SX 94
- 1000Base-LX 94
- 100Base-FX 94
- 4.4.5 Port Mirror 95
- Mirror Port Configuration 96
- 4.5 Link Aggregation 98
- 4.5.1 Static Aggregation 100
- 4.5.2 LACP Configuration 102
- 4.5.3 LACP System Status 104
- 4.5.4 LACP Port Status 105
- 4.5.5 LACP Port Statistics 106
- 4.6 VLAN 107
- 4.6.2 IEEE 802.1Q VLAN 108
- 4.6.3 VLAN Basic Information 111
- 4.6.5 VLAN Membership 116
- 4.6.6 VLAN Membership Status 117
- 4.6.7 VLAN Port Status 119
- 4.6.8 Private VLAN 120
- 4.6.9 Port Isolation 122
- 4.6.10 VLAN setting example: 124
- 4.6.10.3 Port Isolate 129
- 4.6.11 MAC-based VLAN 130
- 4.6.12 MAC-based VLAN Status 131
- 4.6.13 IP Subnet-based VLAN 132
- 4.6.14 Protocol-based VLAN 133
- 4.7 Spanning Tree Protocol 136
- 4.7.3 Bridge Status 144
- 4.7.5 MSTI Priorities 148
- 4.7.6 MSTI Configuration 149
- MSTI Port Configuration 151
- MSTx MSTI Port Configuration 152
- 4.7.8 Port Status 153
- 4.7.9 Port Statistics 155
- 4.8 Multicast 156
- Type Response Time 158
- 4.8.5 IGMP Snooping Status 165
- 4.8.6 IGMP Group Information 166
- 4.8.7 IGMPv3 Information 167
- 4.8.11 MLD Snooping Status 173
- 4.8.12 MLD Group Information 174
- 4.8.13 MLDv2 Information 175
- 4.8.15 MVR Status 179
- 4.8.17 MVR SFM Information 181
- 4.9 Quality of Service 183
- 4.9.2 Port Policing 184
- 4.9.3 Port Classification 185
- 4.9.4 Port Scheduler 187
- 4.9.5 Port Shaping 188
- 4.9.6 Port Tag Remarking 190
- 4.9.7 Port DSCP 192
- 4.9.8 DSCP-Based QoS 194
- 4.9.9 DSCP Translation 196
- 4.9.10 DSCP Classification 198
- 4.9.11 QoS Control List 199
- 4.9.12 QCL Status 203
- 4.9.14 QoS Statistics 205
- 4.9.16 Voice VLAN OUI Table 208
- 4.10 Access Control Lists 209
- 4.10.3 ACE Configuration 213
- IP Parameters 217
- IPv4 frame 218
- Ethernet Type Parameters 221
- 4.11 Authentication 225
- System Configuration 231
- Port Configuration 234
- Port State 242
- Port Counters 243
- 4.11.7 RADIUS Overview 252
- 4.11.8 RADIUS Details 254
- 4.12 Security 269
- 4.12.2 Access Management 273
- 4.12.4 HTTPs 275
- 4.12.5 SSH 276
- 4.12.6 Port Security Status 277
- 4.12.7 Port Security Detail 279
- 4.12.8 DHCP Snooping 280
- 4.12.12 ARP Inspection 286
- 4.13 Address Table 289
- 4.14 LLDP 295
- Fast start repeat count 298
- Coordinates Location 299
- Civic Address Location 300
- F RFC 2474) 301
- 4.14.4 LLDP-MED Neighbor 304
- 4.14.5 Neighbor 308
- 4.14.6 Port Statistics 309
- 4.15 Network Diagnostics 311
- 4.15.1 Ping 312
- 4.15.2 IPv6 Ping 313
- 4.15.3 Remote IP Ping Test 314
- 4.15.4 Cable Diagnostics 315
- 4.16 Power over Ethernet 317
- 4.16.2 System Configuration 319
- 4.16.3 Port Configuration 322
- 4.16.4 PoE Status 324
- 4.16.5 PoE Schedule 325
- 4.16.6 LLDP PoE Neighbours 327
- 4.17 Loop Protection 330
- 4.18 RMON 333
- 4.18.2 RMON Alarm Detail 335
- 4.18.3 RMON Alarm Status 336
- 4.18.5 RMON Event Detail 337
- 4.18.6 RMON Event Status 338
- 4.18.8 RMON History Detail 340
- 4.18.9 RMON History Status 341
- 5. COMMAND LINE INTERFACE 348
- Configure IP Address 349
- 5.2 Telnet Login 351
- 6. Command Line Mode 352
- 6.1 System Command 353
- 6.2 IP Command 359
- VLAN Status 383
- 6.7 Security Command 386
- Security AAA Statistics 440
- 6.9 Link Aggregation Command 452
- 6.11 LLDP Command 458
- 6.12 LLDPMED Command 462
- LLDPMED Policy Add 464
- 6.13 PoE Command 467
- QoS QCL Add 487
- 6.15 Mirror Command 490
- Mirror Mode 491
- 6.16 Configuration Command 492
- 6.17 Firmware Command 493
- 6.18 UPnP Command 494
- UPnP Advertising Duration 495
- 6.19 MVR Command 496
- 6.20 Voice VLAN Command 501
- 6.21 Loop Protect Command 506
- 6.22 IPMC Command 509
- IPMC Parameter URI 520
- 6.24 SMTP Command 526
- 7. SWITCH OPERATION 529
- 7.5 Auto-Negotiation 530
- What is PoE? 531
- 9. TROUBLE SHOOTING 533
- 12345678 536
- APPENDEX B : GLOSSARY 537
- EC Declaration of Conformity 555
Related products and manuals for Routers Planet WGSW-20160HP
Routers Planet WGSW-48040HP User Manual
(16 pages)
(16 pages)
Routers Planet WGSW-48040HP User Manual
(386 pages)
(386 pages)
Routers Planet WGSW-52040 User Manual
(16 pages)
(16 pages)
Routers Planet WGSW-50040 User Manual
(437 pages)
(437 pages)
Routers Planet WGSW-5242 User Manual
(286 pages)
(286 pages)
Routers Planet WGSW-52040 User Manual
(505 pages)
(505 pages)
Routers Planet XGS3-24040 User Manual
(2 pages)
(2 pages)
Routers Planet XGS3-24040 User Manual
(16 pages)
(16 pages)
Routers Planet WGSW-52040 User Manual
(876 pages)
(876 pages)
Routers Planet XGS3-24040 User Manual
(582 pages)
(582 pages)
Routers Planet XGS3-24040 User Manual
(869 pages)
(869 pages)
Routers Planet XGS3-24042 User Manual
(721 pages)
(721 pages)
Routers Planet XGS3-42000R User Manual
(2 pages)
(2 pages)
Routers Planet XGS3-42000R User Manual
(16 pages)
(16 pages)
Routers Planet XGSW-28040 User Manual
(12 pages)
(12 pages)
Routers Planet EPN-103 User Manual
(20 pages)
(20 pages)
Routers Planet EPL-1000 User Manual
(20 pages)
(20 pages)
Routers Planet EPL-2000 User Manual
(20 pages)
(20 pages)
Routers Planet EPL-2000 User Manual
(81 pages)
(81 pages)
Routers Planet EPN-102 User Manual
(2 pages)
(2 pages)
© 2020, manymanuals.com. All rights reserved. | 0.541 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals