Planet ICA-350 Installation Guide download pdf (Page 24)

4. Reset Button

This button is used to restore the all factory default settings.

Sometimes restarting the device will make the system back to a normal

state. However, if the system still got problems after restart, user can

restore the factory default settings and install it again.

Restore the device:

a. Press the button down continuously.

b. Hold the button at least 5 seconds and release it. Then the device

has been restored to default settings and reboot again.

5. Power Jack

The input power is DC 12V.

Note

1. ONLY use package power adapter supplied with the

internet. Otherwise, the product may be damaged.

2. The power adapter is unnecessary when internet

camera is connected to a PoE switch. Otherwise, the

product may be damaged when internet camera is

connected to a PoE switch and power adapter simul-

taneously.

6. MIC in

(audio in)

Connect a microphone to the IP camera.

7. Line out

(audio out)

Connect a loud speaker to the IP camera. This is for voice alerting and

two-way audio.

2.6.3 ICA-HM350 Installation

1. Fix IP camera to desired location with wall mount xture

2. Plug-in Ethernet Cable into RJ-45 connector

Connect an Ethernet cable to the LAN socket located on the IP

Camera’s back panel and attach it to the network.

3. Connect RS485 D+ and D- (if you need to control PT scanner)

4. Connect the attached power adapters to IP camera and heater

(option) and plug-in these adapters into power outlet

5. Done

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

No comments

Planet ICA-350 Installation Guide Page 24