CopyrightCopyright (C) 2005 PLANET Technology Corp. All rights reserved. The products and programs described in this User’s Manual are licens
67Figure 2: POE-150S
67Chapter 4 Hardware Installation4.1 Prior InstallationBefore your installation, it is recommended to check your network environment. If there is
89GHint1. Please check the power requirement of the device that is going to get the power from POE-150S. If the power require-ment is higher tha
89LED of POE-150S / POE-150 will start to flash continu-ously. Figure 5: Connection to POE-150S NOTE:Supporting IEE802.3af, POE-150 will not inje
1011Figure 6: Connection architecture over POE-150/150S4.4 Connect with 802.3af devicesThe above two sections describe the connection of using
1011non-802.3af devices connecting to an IEEE802.3af in-line power device like Power over Ethernet Switch. The gure is as below.Figure 8: Connectio
1213Appendix A RJ-45 pin assignment and cable systemA.1 Pin assignmentThe following table and diagram show the standard RJ-45 receptacle/ conn
1213A.2 Cable system The standard cable, RJ-45 pin assignmentThe standard RJ-45 receptacle/connectorThere are 8 wires on a standard UTP/STP cable and
1415Appendix BTroubleshooting1. The device connected to POE-150S cannot be powered.Answer:a. Please check the POE-150S if it is connected wi
14152. Can device only work at 100Mbps when it is connected to Gigabit Ethernet device?Answer:POE-150/150S will use 4-wire for data transmission (pair
CE mark WarningThe is a class B device, In a domestic environment, this product may cause radio interference, in which case the user may be required t
16This page is intentionally left blank
Part No.:2010-000037-002
Table of ContentsChapter 1 Introduction 1Chapter 2 Package Contents 2Chapter 3 Features & Specifications 3Chatper 4 Hardware Installation 74.1
1This page is intentionally left blank
1Chapter 1IntroductionThank you for purchasing our POE-150/ 150S, IEEE802.3af Power over Ethernet Adapter. This user’s manual is to
23Chapter 2Package ContentsYour Power over Ethernet package shall contains one of the following contents:® POE-150 – the power InjectorPower
23Chapter 3Features & Specifications(1) Features• Provide low-voltage DC power over existing Category 5 cabling to a device with an Ethernet port
45Input voltage 48VDC, 0.4ANumber of devices that can be powered1Ethernet data cable TIA/EIA-568, Category 5/5e cableLED Indicator 1 x power1 x POE re
45Dimensions (L x W x H)93 x 69 x 25 mmEmission FCC class B, CE-mark(3) Product OutlookFigure 1: POE-150
Comments to this Manuals